Description
The new MLRK1-TS1 is a practical and cost-effective way to convert a mechanical Townsteel ED1000, LSDA PD9200 & USCAN series device to an electrified latch pullback device. The retrofit kit will maintain all UL listings on the device and for peace of mind is backed by CAT’s 3-year no hassle warranty. The new unit easily hooks onto the back activating bracket and is secured with (2) screws, in a matter of seconds. The only hole you’ll need to drill is for the wire raceway. PTS allows for a smooth post-installation adjustment of the latch/latches. Last but not least, it features an updated MM4S module with 2 different energy consumption settings from energy-conscious to high torque to get the tough jobs done.
Features:
Next Generation MM4S Smart Module: On board diagnostics with audible feedback for adjustment and power issues.
“PTS”: 5 second electronic adjustment for easy post installation adjustment.
Electric dogging rated for continuous duty – Auto re-engage if push pad is pulled from dogged position.
Low Current Draw – Field switchable to “High Torque” mode.
Up to 300′ wire run with 2-18ga wire – Long wire runs provides installer with convenience of placing the Command locking hardware power supply in a centralized location; i.e. the same closet as the access control panel.
Push-n-Go Pigtail + 6′ cable with Quick Connect for MM4S module to easily connect to power supply lead.
3-year “no hassle” warranty
Voltage Range
24VDC +/- 10%
System Protection
Unit Shutdown when Voltage exceeds 28VDC
Standard
Average Current Peak: 900mA, Average Current Hold 200mA
High Torque
Average Current Peak: 2A, Average Current Hold: 250mA
PTS Adjustment
approx. 1/4″
Wire Run
300′ with 18ga wire
Weight
2 lbs
Downloads:
Spec Sheet
Installation Instructions
