Command Access – Field Installable Motorized Latch Retraction Kit – For Cal-Royal Series 9800 & 2200 Exit Devices – 2/18 Gauge – 24 to 28 VDC

$304.45

The MLRK1-CAL is a practical and cost-effective way to convert a mechanical Cal Royal 9800 & 2200 series exit device to an electrified latch retraction device while maintaining the UL listing. Our easy-to-install motor-driven kit installs in moments. It is equipped with PTS technology allowing for an easy post-installation adjustment of the latch/latches. 

Description

The MLRK1-CAL is a practical and cost-effective way to convert a mechanical Cal Royal 9800 & 2200 series exit device to an electrified latch retraction device while maintaining the UL listing. Our easy-to-install motor-driven kit installs in moments. It is equipped with PTS technology allowing for an easy post-installation adjustment of the latch/latches. 

Features:

MM4S Smart Module: On-Board diagnostics with audible feedback for adjustment and power issues

Remote MM4S module for easy accessibility and servicing 

“PTS”. 5-second electronic adjustment for easy post-installation adjustment 

Electric dogging rated for continuous duty – Auto re-engage if push pad is pulled from dogged position

Low current draw-field switchable to  “High torque” mode

Up to 300′ wire run with 2-18ga wire – Long wire runs provide the installer with the convenience of placing the command locking hardware power supply in a centralized location; i.e., the same closet as the access control panel 

8′ cable with quick connect for MM4S module to easily connect to power supply lead

Request-to-exit kit available

3-year “no-hassle” manufacturer warranty

Manufacturer Parent

Command Access 

For Use with

Cal Royal 9800 and 2200 Series Exit Device

Function

Latch9 Retraction Kit

ADA Compliant

No

Function Family

Part/Component

Standards

UL Listed

Voltage

24 to 28 VDC

Product Type

Electronic Part/ Accessory

Wire Gauge

18 ga

Product Length

300′ 

Warranty

3-year no-hassle warranty

Protection

Unit Shutdown when voltage exceeds 28VDC

Standard Torque

Average Current Peak: 900A, Average Current Hold 215mA

High Torque

Average Current Peak: 2A, Average Current Hold: 250mA

PTS adjustment 

approx. 1/4″

Wire Run

300′ with 18ga wire

Device Cutdown Details

All the way to the push-pad

 

Downloads:

Cut Sheet

Instructions