Description
This UL Listed panel controls 4 doors via RFID card access and is managed by the easy-to-use Malibu access control module and 4 door controller. It is a power supply/charger that converts a 115VAC/60Hz input into a single 12VDC or 24VDC non-power-limited output. Mounting magnets are included to accommodate screws and nylon standoffs to allow for mounting various boards/accessories in any metal enclosure or backplane.
**Back up battery not included**
**4 door controller not included**
Features:
Input: 115VAC, 60Hz, 3.5A
Output: 12VDC or 24VDC selectable output
6A continuous supply current
Filtered and electronically regulated output
Short circuit and thermal overload protection
Built-in charger for sealed lead acid or gel-type batteries
Automatic switch over to stand-by battery when AC fails
AC fail supervision (form “C” contacts)
Notification trigger is selectable for 30 seconds (factory set) or 6 hours
AC input and DC output LED indicators
Customize the metal enclosure or back plane to accommodate power supplies, distribution boards, access controllers and accessories
Easy, fast installation saves time and labor – no drilling required
Can be reused and re-positioned
Wall mount for indoor use
Specifcations:
Brand
Malibu
Mounting Magnet Materials
Zinc Alloy cover eliminates the possibility of EMI/ RFI
Max Weight of Mounting Magnets
26 lbs max strength
Hardware Included
screws and standoffs
Enclosure Dimensions
13″W x 13.5″H x 3.25″D (330 mm W x 343 mm H x 83 mm D)
Combination Knockouts
1/2″ and 3/4″ combination knockouts
Operating Temperature
0° C to 49° C (32° F to 120° F)
Storage Temperature
– 20° C to 70°C ( – 4° F to 158° F)
Relative Humidity
85% +/- 5%
BTU/Hr (approx)
12VDC: 37 BTU/Hr, 24VDC: 74 BTU/HR
System AC input VA requirement
402.5VA
Package Entails:
1 x Power Supply
1 x Panel Enclosure
4 x Mounting Magnets
Downloads:
Spec Sheet
Installation Instructions
